Filter
Top Products
Fastmark 600 Series User's Guide 22
8. Loop the ribbon over the Print Head Module. Insert the Take-up Core into the Take-Up
Area by first compressing the right side spring and snapping the left side of take-up core
into the left side of the notched wheel. Make sure that the slots in left side of the core
mate with the notches on the left side ribbon drive wheel.
Figure 13 – Ribbon Take-Up Installation
9. To remove any slack in the ribbon, manually rotate the Take-up Core Wheel until the
ribbon from the Supply Holder is snug around the Print head Module and onto the Take-
up Core .
Figure 14 – Ribbon Installation
Ink Side of the Ribbon
Print Head Module
Take-Up Core
Take-Up Core Wheel