Filter
Top Products
Fastmark 600 Series User's Guide 33
Printing the Configuration Label
1. Ensure the printer is powered off.
2. Make sure that Media width of 4 inches is installed and that the MEDIA WIDTH feature
is set for 4.00 inches.
3. Verify that the media is properly loaded and routed as detailed in Loading Media
Section.
4. While pressing and holding the FEED key, power on the printer.
5. When the printer begins to print the configuration label you may release the FEED key.
Note:The feature settings on your printer may vary based on any setup changes made or
firmware version installed in the printer.
When a PAL application is loaded into the printer the Print Sample will indicate this
on the Drive A or Drive B lines
Figure 31 – Configuration Print Sample
Media Type
Thermal Transfer
Media Sensing Gap
Sensor Threshold 70
Media Length 4.00 Inches
Media Width 4.00 Inches
Present Distance +0.24 Inches
BackFeed Mode Enable
Present Sensor Disabled
Cutter Mode Disabled
Vert Print Align 0.00 Inches
Horz Print Align +0.20 Inches
Vert Size Adjust 0
Print Darkness - 6
Print Speed 4
Interface Select Auto Select
COM1: Baud Rate 9600
COM1: Parity None
COM1: Data Bits 8
COM1: Handshake RTS & XON
COM1: PAL Xmit Disabled
Emulation Mode PAL Emulation
Date Not Installed
Time Not Installed
Daylight Saving Disabled
Firmware Rev. 110156 A
PAL Boot Drive Auto Detect
Max Media Length 12.00 Inches
Keypad Lockout Disabled
Label Count 582
Drive A: (131072) Empty
Drive B: (262144) Empty
Drive C: (0) Empty
Drive D: (32768) Empty