Filter
Top Products
Fastmark 600 Series User's Guide 73
Other User Detected Errors
The following issues may be detected by the user but may not reported by the printer to the Feature Management
Mode.
Description of Issue Possible Problem Possible Correcting Procedures
Printer not attached to a
power source.
1. Verify Power Plug on back of printer is pushed firmly
in.
2. Verify Power Adapter is connected to a known power
source.
3. See Maintenance Manual for procedure of verifying
and changing of the fuse.
Power Switch is not in the
on position.
1. Verify Switch is in the ‘1’ position.
2. Toggle switch to verify both off and on condition.
No power or
LEDs are not on
Is the printer in FeatureMan
mode?
1. Press the PAUSE key to see if the Ready LED comes
on.
2. Cycle Power on the printer.
3. Replace the printer.
Media Latches not closed. 1. Open the Top Cover.
2. Verify Media is installed according to the Loading
Instructions.
3. Press firmly on the top of the Printhead Mechanism
and verify the both the right and left latches are locked.
4. Close the Top Cover.
Media not feeding
properly
Media not installed
correctly
Verify Media is installed according to the Loading
Instructions.
Media is drifting to
the right as it comes
out of the printer.
Media Guides not in the
proper position.
1. Open the Top Cover.
2. Verify Media is installed according to the Loading
Instructions.
3. Verify that the right Media is in the proper Position.
The media needs to be snug between the left and right
guides.