AMX NXR-ZGW/-ZRP Network Card User Manual


 
Overview
3
NXR-ZGW/-ZRP
NXR-ZRP Specifications
The following table outlines the specifications for the NXR-ZRP.
NXR-ZRP (FG5791-02) Specifications
Dimensions (HWD): 906 x 2.500 x 3.424 (23.01 mm x 63.50 mm x 86.96 mm) depth does not
include antenna
Weight: 0.25 lbs (113.39g)
Power: 10.5 - 18 VDC; 13.5 (nominal operation voltage)
Memory: 16 Mbytes of Flash
1 Megabit external memory
Radio Specifications:
Frequency
IEEE 802.15.4
Operating channels
11 - 26
Modulation technique
•DSS
Output power
Region/country specific
Coverage area 165 feet (502.m)
Firmware/Software
Specifications:
Communications The NXR-ZRP communicates with a Netlinx master via a NXR-ZGW. The
NXR-ZGW communicates with a Netlinx master over TCP/IP encapsulating the
ICSP protocol via a physical Ethernet connection. The ICSP device number
can be set via the browser-based management system.
Front Components:
LEDs PWR/STATUS - A green LED that blinks to indicate the device is
programmed and communicating properly. Power ON, but no master
connection, is indicated with a solid light; Power OFF is indicated with no
light.
ICSP - The LED is solid when ICSP connection is in place with the NetLinx
master.
RF - The LED is solid when end devices are connected; end devices not
connected is indicated with no LED light; the LED blinks to indicate activity.
Antenna Mount A reverse SMA connection that supports a 2.4GHz antenna.
Reset Button Press and hold for approximately 10 seconds to return the NXR-ZRP to factory
default settings.
Rear Components:
Power connector 2-pin 3.5mm Phoenix connector
Certifications: FCC ID: CWU-ZRD
IC ID: 5088A-ZRD
•CE
IEC-60590
•TELEC
Operating/Storage
Environments:
Operating Temperature: -30°C (-22°F) to 70°C (158°F)
Relative Humidity: 5% to 85% non-condensing; intended for indoor use only
Included Accessories: 2.4GHZ, MONO, RSMA, 3.5IN, 2.0DBI Antenna (70-0012-SA)
Rubber feet
Velcro mounting strip
Power Supply (24-5791-SA)