APC AP9208 Power Supply User Manual


 
13
UPS STATUS (Smart-UPS and Matrix-UPS)
Item Description
Utility Line
Utility line input, in volts AC RMS.
UPS Output
UPS output to the load, in volts AC RMS.
UPS Load
Connected load as a percentage of the rated capacity of the UPS.
Run Time
Estimate of the total run time currently available from the
UPS, based on present load and battery, in minutes.
Load Power
Amount of power being drawn by the load, in volt-amps (if
supported by the UPS).
Load Current
Amount of current being drawn by the load, in amps (if
supported by the UPS).
UPS Temp
Current temperature inside the UPS, in degrees Celsius.
Freq
Output frequency of the UPS, in hertz.
Last Xfer
Reason for the last UPS transfer to battery. Possible results
are: Test, Low Voltage, Hi Voltage, Rate of Change, and
Notch/Spike.
Voltage
Total voltage of the UPS batteries, in volts DC.
Capacity
Battery charge as a percentage of capacity.
Smart Cells
Number of Smart Cell battery packs connected to the UPS
(only with Matrix-UPS).
Bad Cells
Number of Smart Cells connected to the UPS that have gone
bad (only with Matrix-UPS).
Batt Date
Date of the last battery change.
Self Test
Results of the last UPS self-test. Possible results are: OK,
None (not available), Unable to Test (invalid results due to
overload), and Battery Failed (due to insufficient capacity).