Filter
Top Products
13
Multiple SmartSlot Installation
continued
If your UPS has
one SmartSlot
accessory slot
If your UPS has exactly one SmartSlot accessory slot, use
this accessory slot for the SmartSlot device with the lowest
priority. Install SmartSlot devices with higher priority in an
Expansion Chassis (AP9600) or Triple Chassis (AP9604—
see “Installation in the APC Triple Chassis” on this page).
If you are using a Symmetra PowerArray, see “Installation
in the Symmetra PowerArray” on page 14.
Installation in
the APC Triple
Chassis
To install SmartSlot devices in the APC Triple Chassis
(AP9604), note that the slots are numbered on the rear
panel. The following figure shows the rear panel of the
Triple Chassis with the PowerNet
SNMP
Adapter installed
in slot #3, Call-UPSII in slot #2, and the Interface Expander
in slot #1. (In this scenario, Measure-
UPS
II could be
installed in the accessory slot of the
UPS
.)
Continued on next page