Filter
Top Products
CHAPTER 3: MENU COMMANDS
12
Logging Menu (continued)
Menu Item Function
List Event Groups Lists the specific events in each group.
Power Events
UPS Control Events
User Activities
UPS Fault Events
Measure UPS Events
Clear Log Clears the view log. Does not clear the active event lists.
Status Menu
The Status Menu displays load, battery/power module, voltage, and electrical current information.
Menu Item Function
Ø Vin Vout Iout Displays input voltage(s), output voltage(s), and output current information.
% load assuming
no redundancy
Compares the current load to the total capacity of all power modules.
% load allowing for
n+ redundancy
Compares the current load to the total capacity of all power modules, except the power
modules that are set aside by the “Fault Tolerance” alarm threshold. For example, if there
are four power modules installed, and the fault tolerance alarm threshold is set to “1,” this
percentage of load uses only three power modules for the calculation. See Setup-Alarms to
set the redundancy level.
Frequencies Displays the measured input and output frequencies.
Battery Status
Screen
Displays battery module capacity, runtime, and status information.
Power Module
Status Screen
Displays power module capacity, fault tolerance, and status information.
Alarm Thresholds
Status Screen
Displays the user-defined alarm settings. See Setup-Alarms to set these alarm thresholds.
Miscellaneous
Status Screen
Displays the summary result Self-Test, Last System Transfer, Operating Mode, and status
of intelligence and redundant intelligence modules.