Filter
Top Products
Emerge Card Remote Access User Guide Configuration •
••
• 18
Install and Configure the Emerge Software
Once your new EmergeCard is installed you will need to install your Emerge software.
To install and configure your Emerge software
1 Insert the Emerge CD into the System’s CD-ROM drive.
2 Open up the folder "Update.xxx."
3 Run Updatexxx.exe.
4 Restart the system.
5 Follow the Setup Wizard instructions to complete setup of your EmergeCard.
Note
Running other applications along with the Emerge may affect operation and performance.
Setting up the Target Systems
Prior to operation with the Emerge, set up your target system(s) to ensure optimum results:
Set your target system mouse movement
• Set standard PS/2 mouse drivers to SLOW.
• Set Intellimouse mouse driver speed to the center position, set Acceleration to NONE and
deactivate the mouse snap.
Set your target display
Select a supported resolution for each of the servers to be accessed by Emerge. Emerge supports
standard high-resolution VGA video up to 1024 x 768 @ 75Hz refresh rate. Setting your servers at
unsupported resolutions may produce undesirable results. Reduce your target system resolution and
color depth to improve performance by decreasing the amount of image data passed along to the
Emerge.