Asante Technologies IC3624PWR Switch User Manual


 
15
IntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit
3.5.1 Recommended Tools
You need the following tools and equipment (not included) to install the switch into an equipment rack:
Flat head screwdriver
Phillips head screwdriver
Four mounting screws for each device you plan to install in a rack (not included with the switch)
Antistatic mat or foam
3.6 Installing the Switch
The switch can be mounted in a standard 19-inch equipment rack or place on a desktop or shelf. Mounting
instructions for each type of site follow.
3.6.1 Mounting the Switch in a Rack
When installing this unit in an empty rack, mount it at the bottom. When mounting this unit in a partially filled rack,
load the rack from the bottom to the top with the heaviest component at the bottom. Follow these steps to properly
install the switch into an equipment rack.
Caution: Before continuing, disconnect all cables from the switch.
To mount the switch onto an equipment rack:
Place the switch on a flat, stable surface.
Locate a rack-mounting bracket (supplied) and place it over the
mounting holes on one side of the switch.
Use the screws (supplied) to secure the bracket (with a Phillips
screwdriver).
Repeat the two previous steps on the other side of the switch.
Place the switch in the equipment rack.
Secure the switch attaching the mounting brackets onto the equipment rack with the screw supplied with the unit.