Filter
Top Products
73
IntraCore IC3624PWR Layer 2 PoE Switch with Dual Gigabit
The following procedure gives the steps to follow when using the web interface. The process is similar with either the
CMI or CLI interfaces.
1. Go to Main Menu> Switch Tools Configuration> Software Upgrade Menu>TFTP Software Upgrade.
2. Set up the IP address and Image File Name.
3. Verify information such as the IP address for the TFTP Server and the file name of the new software image.
4. Verify the TFTP server and IP connection between server and switch are working properly.
5. Select Upgrade Image.
The switch downloads the image from TFTP Server and replaces the runtime image on Flash.
Note:
Use a RS-232 serial port connection to the switch during the software upgrading procedure. When using a
Telnet Session or web interface alone, your connection to the switch will not be available until the switch has
completed its boot up and entered the Spanning Tree forwarding mode. This can take up to three minutes.
6.5.2 Configuration File Upload/Download
Use this submenu to set addresses, establish configuration file names, upload and download files from one server to
another.
Map: Main Menu->Tools->Configuration File Upload/Download