Filter
Top Products
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-22-2
2-22-2
2-2
2.1 Chassis cover
2.1.12.1.1
2.1.12.1.1
2.1.1
Removing the front coverRemoving the front cover
Removing the front coverRemoving the front cover
Removing the front cover
1. Use a Phillips screwdriver to
remove the screw on each front
end of the top cover.
3. Firmly hold the cover and slide it
toward the rear panel for about
half an inch until it is disengaged
from the chassis.
2. Loosen the two thunbscrews on
the rear panel to release the top
cover from the chassis.
4. Released a drive tray by pushing
the spring lock to the right. Then
, firmly hold the tray level and
pull all the drive trays out of the
bay.