Filter
Top Products
Chapter 2: Hardware setup2-18
2.7 Hard disk drives
2.7.1 Installing a hot-swap SATA/SCSI HDD
Follow the instructions in this section to install a hot-swap SATA (PA4 model) or
SCSI (PS4 model) hard disk drive (HDD).
1. Open the front bezel to access the hot-swap drive trays.
2. Release a drive tray by pushing the
spring lock to the right, then pulling
the tray lever outward. The drive
tray ejects slightly after you pull out
the lever.
3. Firmly hold the tray lever and pull
the drive tray out of the bay.
4. An empty drive tray requires a metal bracket for support. Use a Phillips
(cross) screwdriver to remove the bracket when you are ready to install a
hard disk in the drive tray.
Metal bracket
Tray leverSpring lock