Filter
Top Products
4-11ASUS TS300-E3/PA4 & PS4
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
For P5MT model only:
If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, RAID 0+1, and software RAID 5 configuration
using the Intel
®
Matrix Storage Technology or RAID 0, RAID 1 and RAID 0+1
configuration using the LSI MegaRAID
®
utility embedded on the Intel
®
ICH7R
Southbridge.
Serial ATA hard disk drive connection
Connector Setting Use
SATA1/SATA2 Master Boot disk
SATA3/SATA4 Slave Data disk
These connectors are set IDE mode by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors. If you intend to create
a Serial ATA RAID set using these connectors, set the Configure SATA as item in
the BIOS to [RAID]. See section “4.3.4 IDE Configuration” for details.
Important notes on Serial ATA
• You must install Windows
®
2000 Service Pack 4 or Windows
®
2003 before
using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID
0/RAID 1) is available only if you are using Windows
®
2000/2003.
• Use only two Serial ATA RAID connectors for each RAID 0 or RAID 1 set.
• When using the connectors in IDE mode, connect the primary (boot) hard
disk drive to the SATA1 or SATA2 connector. Refer to the table below for the
recommended SATA hard disk drive connections.
LAN2
®
P5MT Series SATA connectors
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA
_RXP2
RSATA
_RXN2
GND
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA
_RXP1
RSATA
_RXN1
GND
SATA4
GND
RSATA_TXP4
RSATA
_TXN4
GND
RSATA
_RXP4
RSATA
_RXN4
GND
SATA3
GND
RSATA_TXP3
RSATA
_TXN3
GND
RSATA
_RXP3
RSATA
_RXN3
GND