Filter
Top Products
14
Health and Status Monitor page
1 If you are not already in the FastStream GUI,
type the IP address of your appliance, as found
in
Use the FastStream VT 5300 GUI
on page
23, in a standard browser, click Enter Here and
type in your username and password.
2The Monitor VTL page appears. On the menu
at the left hand side of the page, click on
Diagnostics.
3The Health and Status Monitor page appears.
If you click Details, added information about
each parameter appears on the Configuration
Display page (refer to
Configuration Display
page
below).
• RAID Groups
RAID Group names, RAID status, available
Hot Spares and number of faulted drives
• Environmental Status
Temperature and voltage
• Interface Status
Ethernet management port link status and
Fibre Channel port link, speed and
connection mode
• Drive status by port
Size and status
Configuration Display page
Clicking on
Details
in the
Health and Status
Monitor
page (refer to details above) gives you
added information about each parameter on the
Configuration Display
page. You may view the
details of any parameter from this page.
• RAID Groups
RAID Group names, RAID status, available Hot
Spares, number of faulted drives, RAID Level,
Interleave and total capacity of each RAID
Group.
• Drives
Drive Configuration by port, including drive size
and status
• Interfaces
Ethernet management port link status and Fibre
Channel port link, speed, connection mode,
Node Name and Port Name.
Note
At any point, if you do not want to continue
before you click
Commit,
click on the
Cancel
button to return to the previous setup menu.
Phone home: E-mail messages
E-mail notification allows the FastStream VT
5300 to send an E-mail message to you, a network
administrator or other users when certain events
occur with the FastStream. Serious error
messages are sent immediately, while messages
for less serious errors are sent every 15 minutes.
• Types of errors
• SCSI device errors such as medium error,
aborted command and hard error
• Device transitions from online to offline
• Critical and warning temperature conditions
• Critical and warning voltage conditions
• Power recycle/power failure conditions
• Warning messages
• device down
• medium error
• abort command
• Warning levels
• All: warnings, critical events and
informational messages are sent
• Critical: critical event E-mails are sent
• Warning: warnings and critical event E-
mails are sent
• None: no E-mails are sent
You may send E-mails to up to five E-mail
addresses and designate which conditions prompt
each E-mail notification.
For example, a recipient with a critical severity
level only receives critical messages and not
warning or informational messages.
When an event occurs that warrants E-mail
notification, the FastStream VT 5300 sends the