ATTO Technology 5300 Computer Hardware User Manual


 
x
Appendix
CLI command explanations
Command Line Interface commands are listed
alphabetically with explanations of what they are
used for, their defaults and syntax.
CAUTIONCAUTION
Do not use CLI unless you are directed to
by an ATTO technician.
Changing parameters may cause loss of
data and/or disruption to performance and
reliability of the FastStream.
The FastStream VT 5300 GUI is the
preferred method to operate and manage
the FastStream VT 5300. Refer to
Interface
options
on page 23 for details
AutoMap
Automap automatically maps a subset of target
devices visible to the firmware. All previous maps are
deleted.
AutoMap
AutoResume
Enables/disables the automatic continue feature for
interrupted rebuild, erase and write pattern operations at
startup. If AutoResume is enabled, all interrupted rebuild,
erase and write pattern operations are continued at
startup. Optional parameter GroupName specifies the
RAID Group whose Restart features to be set. If no
GroupName is specified, all existing RAID Groups are
affected.
Default: all disabled
set AutoResume [Rebuild | Erase | WritePattern | all]
[enabled | disabled] <GroupName>
BlockDevClean
Removes any ATTO configuration data from the block
device with the specified BlockDevID. BlockDevID is the
index of a block device provided by the
BlockDevSca
n
CLI command.
BlockDevClean [BlockDevID]
BlockDevIdentify
Causes the I/O LED of the drive to illuminate for one
minute if it is accessible through the SCSI port
.
CAUTIONCAUTION
The BlockDevIdentify command is
intended for diagnostic purposes only.
Executing this command may adversely
impact the performance and throughput
of the FastStream for the time that the
LED is illuminated.
ts SCSI port.
BlockDevIdentify <Groupname> [BlockDevID | MberIdx]
BlockDevIDStop
Turns off the IO LED of a previously identified disk drive.
BlockDevIDStop
BlockDevScan
Lists all currently connected physical drives along with
any potential RAID Group association. Each block device
listed is assigned a unique index at the time of the scan to
identify drives for other CLI operations.
BlockDevScan
BridgeModel
Reports model information about the FastStream.
get BridgeModel
BridgeName
Specifies the eight-character name assigned to the
FastStream used to identify individual FastStream units.
It is not the World Wide Name. The string is
alphanumeric, eight characters long,.
Default: ““
set BridgeName [value]
Requires a SaveConfiguration command
get BridgeName
ClearEventLog
Clears the contents of the event log. No new entries are
recorded until ClearEventLog has completed.
ClearEventLog
Date
Regulates the current date for this unit. The date range is
1/1/2000 to 12/31/2099.
Default: 01/01/2000
set Date [MM] [DD] [YYYY]
get Date
Voltage get voltage
WrapEventLog enabled set wrapeventlog disabled
zModem zmodem receive
Command Default Example