Filter
Top Products
15
CONTENTS
2.1 OVERVIEW
ALS
20x
256
GB
Electronics
Interfaces
Internal Interfaces
6) Not yet available
Status messages, test functions,
product profiles
Processor: 32 Bit CPU MIPS Core
RAM: 16MB
ROM: 4 MB
Control panel: graphical display with
128x 32 pixels, 2/4 lines,
5 buttons
Sensor interfaces for
external sensors
Label sensor:
Alternative label
sensor:
Product sensor:
APSF-sensor (Rotary
encoder):
Stock sensor:
(plug in each case 4-
pin M12)
Wenglor OPT242-P800
optical, NPN, 24 V, con-
trollable sensitivity
PNP/NPN, 24 V
PNP/NPN, 24 V
single-phase/two-phase,
PNP/P-P, 24 V, max.
20 kHz
PNP, 24 V
Internal sensor interfac-
es:
Material unwinder
Pressure roller
Dancer arm
Light barrier
not used
bi-phase light barrier en-
coder
PLC interface
Outputs:
Inputs:
Sub D15, optically insu-
lated, optionally via two
8-pin M12 (separate in-
puts/outputs in each
case)
4x PNP, 24V, a maxi-
mum of 500 mA/channel,
total permissible output
current: 1500 mA
3x PNP/NPN, 24 V
Data interfaces:
Serial:
Ethernet:
USB:
CF card:
Control panel
interface:
RS232C (Sub-D9),
max. 115200 Baud
10/100 BaseT (RJ45)
Device V1.1 (USB B),
‘Full speed’ operating
mode, 12MBit/s
Slot for 1 CompactFlash
card
RS 485 (Mini DIN 6 con-
nection) for remote con-
trol
RFID Connection for RFID
read/write unit (special
equipement)
6)
Applicator Interface Connection for Applicator
Interface (AI) board (spe-
cial equipement)
Connector for additional
motor driver
not used
Automatic halt, if ... the label roll is spent or
no gap was found.
...the max. admissible
number of missing labels
is reached.
Test functions: Automatic diagnostics
check when switched on
Output of system data via
data interface
Status indicators: Label counter
Operating hours counter
Storage locations for
product profiles:
up to 16