Filter
Top Products
44
CONTENTS
4.2 CONFIGURATION AND MONITORING
ALS
20x
256
GB
4.2.2 Monitoring functions
While in dispensing mode, an electronic controller
monitors the following functions:
Missing labels
A label missing from the label roll does not normally
affect the dispensing operation, because the label feed
continues until a label’s edge passes under the label
sensor.
Nonetheless, it can be important that missing labels are
reported. By configuring the function LABEL SETUP >
Miss. label tol., you can specify whether an error message
is triggered after one or several missing labels.
Material end
The following message appears when the material roll
is empty:
– The machine stops.
£ Press the button to delete the message.
£ Remove the rewound backing paper.
£ Insert a new material roll (see “Inserting label
material” on page 32).
Material tear
If the material path tears, one of these two messages
appears:
– Which message appears depends on where the
material path is torn.
– The machine stops.
£ Press the button.
Status num: 5002
Material end
Status num: 5002
Material end
Status num: 5140
Rewinder control