Avery 204 Label Maker User Manual


 
4
CONTENTS
1.2 SAFETY INSTRUCTIONS
ALS
20x
256
GB
1.2.2 Operational safety of the unit
Proper usage
The ALS 20x Label Dispenser is a fully automatic unit
for attaching self-adhesive labels to products or
packaging. The company operating the unit must install
it with suitable equipment to protect operating
personnel from danger; for example, the danger of the
hands or fingers being crushed by reaching in between
the product and the dispensing edge.
WARNING!
Improper usage of the unit can cause
accidents, property damage and production
downtime!
£ Only use the unit in accordance with the
instructions specified in this manual.
£ Do not operate the unit without the
required safeguards.
£ Only configure the unit in accordance
with this manual and with the required
care.
£ Only use original accessories.
£ Do not make any modifications or
alterations to the unit.
£ Repairs to the device may only be
performed by authorised specialists who
are aware of the risks involved.
Protection against injuries by electrical
current
WARNING!
The machine operates using mains voltage!
Touching live electrical parts may expose
you to hazardous electrical currents and
may lead to burns.
£ Only operate the unit once the housing
has been reassembled properly.
£ Only connect the unit to a properly fitted
power socket that is grounded.
£ Before cleaning, switch off the unit and
remove the power cable from the socket.
£ Only link the unit to devices that fulfil the
SELV (safety extra-low voltage) circuit
requirements specified in EN60950.
WARNING
The unit is not protected against splashing
water in its standard model.
£ Keep the unit dry.
£ If liquids have penetrated the unit, switch
it off and disconnect or unplug the power
cable immediately. Inform a service
technician.
WARNING
The device is only completely disconnected
from the mains if the power cable is
unplugged.
£ Make sure the power supply socket is
accessible.
£ In case of emergency, switch off the
device and disconnect the power cable.
CAUTION
A too high or low supply voltage can damage
the unit.
£ Only operate the device using the system
voltage indicated on the nameplate.
£ Ensure that the mains voltage set on the
unit is the same voltage as that provided
by the electricity supplier.