Filter
Top Products
10. Image files menu
10. IMAGE FILES MENU
Overview
• Load file
• Auto Image
• Edit file
• Rename file
• Copy
• Delete
Introduction to image files
An image files contains the main characteristics of a source (number of active lines,...). The projector’s memory contains a list of
files corresponding to themost commonsources, these are the standard files (file extension = *.s). When anew
source corresponds
to one of these files, a custom file (file extension =*.C) is created and saved for future use.
When there is a little difference, the file can also be loaded and then edited until the source specs are reached.
The AutoImage function creates automatically the best suited image file (custom file) for a new source. Au-
toImage is used when:
- a new source is detected : AutoImage creates a new custom file which can always be edited if ne
cessary.
- the AutoImage button on the RCU is pressed
AutoImage works only in full screen mode
If the AutoImage function does not succeed in finding a file and no file is loaded (load list is empty), which
means that the source is not displayed, then use the copy function,
10.1 Load file
Howtoloadafile?
1. Press MENU to activate the Toolbar
2. Press → to select the Image files item
3. Press ↓ to Pull down the Image files menu
4. Use ↑ or ↓ to select Load (image 10-1)
5. Press ENTER
A dialogbox is displayed (image 10-2)
6. Use ↑ or ↓ to select the desired file
Tip: For more info about the available image files and the specification
s, see appe ndix B
7. Press ENTER
The file is loaded and the image is adapted.
Image 10-1
R5976455 BARCO ULTRA REALITY 7000 30062003 65