Filter
Top Products
2. Installation Guidelines
2. INSTALLATION GUIDELINES
Overview
• Safety warnings
• Installation guidelines
• Projector configurations
• Lenses
2.1 Safety warnings
Before installing theprojector,read first the safety instructions inthe safety manual(R5975258) deliveredwith
the projector.
Insure that the projector is installed in an easy to evacuate room in case of a lamp explosion.
2.2 Installation guidelines
Ambient temperature check
Careful consideration of things such as image size, ambient light level, projector placement and type of screen to use are critical to
the optimum use of the projection system.
Max. ambient temperature : 40 °C or 104 °F
Min. ambient temperature : 0 °C or 32 °F
The projector will not operate if ambient air temperature falls outside this range (0°C- 40°C or 32°F-104°F).
Environment
Do not install the projection system in a site near heat sources such as radiators or air ducts, or in a place subject to direct sunlight,
excessive dust or humidity. Be aware that room heat rises to the ceiling; c
heck that temperature near the installation site is not
excessive
Harmful Environmental Contamination Precaution
Environment condition check
A projector must always be mounted in a manner whichensures the free flow of clean air into the projectors ventilation inlets as well
as free flow at the ventilation outlets. The installati
on must also allow easy access to the consumable parts ( dustfilters, lamps, ...)
For installations in environments where the projector is subject to airborne contaminants such as that produced by smoke machines
or similar (thesedeposit a thin layer of greasy residueupon the projectors internaloptics and imaging electronic surfaces, degrading
performance), then it is highly advisable and desi
rable to have this contamination removed prior to it reaching the projectors clean
air supply. Devices or structures to extract or shield contaminated air well away from the projector are a prerequisite, if this is not
a feasible solution then measures to relocate the projector to a clean air environment should be considered. Make sure that the
projector never runs with dirty dustfilters as
this will dramatically reduce the lifetime of the consumables. It is advised to clean the
dustfilters on a regular basis and to replace them at any lamp change. Barco reserves itself the right to refuse warranty replacement
of consumablesifthey have been used ina projector with dirty airfilters. Only use themanufactures recommended cleaningkit which
has been specifically designed for clea
ning optical parts, never use industrial strength cleaners on a projectors optics as these will
degrade optical coatings and damage sensitive optoelectronics .
Failure to take suitable precautions to protect the projector from the effects of persistent and prolonged air contaminants will culmi-
nate in extensive and irreversible ingrained optical damage. At this stage cleaning of the internal optical units will be non-effective
and impracticable. Damage of this nature is under no circumstances covered under the manufactures warranty and may deem the
warranty null and void. In such a case the client shall be held solely responsible for all costs incurred during any repair. It is the
clients responsibility to ensure at all times that the projector is protected from the harmful effects of hostile airborne particles in the
environment of the projector. The manufacture reserves the right to refuse warranty repair if a projector has been subject to wantful
neglect, abandon or improper use.
What about ambient light ?
The ambientlight level of any room is made up of direct or indirectsunlight and the light fixtures inthe room. The amount of ambient
light will determine how brig
ht the image will appear. So, avoid direct light on the screen. Windows that face the screen should be
R5976455 BARCO ULTRA REALITY 7000 30062003
5