Filter
Top Products
3-1
Location and Functions of Control
5975967 BARCOGRAPHICS 9200 030798
3
RS 232 IN
REMOT E
PROJECTOR MODE :
GREEN - OP ERATI ON
RED - ST ANDBY
COMMUNI CAT I ON PORT
(8 00- PERI PHERAL S)
RS232 OUT
IR- A CK N OWL E DG E D
IR-RECEIVED
DI AG NOS T IC S
CODE IR-RECEIVER
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
LOCATION AND FUNCTIONS OF CONTROL
Front Panel Terminology
IR-Received : IR signals are received but not recognized
by the projector.
Diagnostics code : a) source number
b) error code : a two digits error code is displayed when
something goes wrong inside the projector.
IR receiver : receiver for control signals transmitted from
the RCU.
Power switch : '1' = on, '0' = off
Power input : autoranging from 90 to 240 Vac.
Identification plate : name, serial number, art. number.
Voltage identification plate : name, art. number.
1
2
3
RS232 IN : to allow communication with external compu-
ter, e.g. IBM PC or compatible, Macintosh ...
RS232 OUT : used to connect to next projector, RS232IN
plug (communication link for PC or MAC to the next
projector).
Communication port : allows communication with the
800 peripherals.
Remote : remote input for wired remote control.
Projector mode indication : indicates the status of the
projector.
Light off : power switch is not pressed.
Red light : power switch is pressed, projector in
stand by mode.
Green light : projector in operational mode.
IR-Acknowledged : IR signals are recognized.
4
5
Control Panel Terminology
a. Local keypad
Gaining access
6
7
8
9
10
11
12
The keypad is located behind a door, screened with the name
of the projector.
To open the door, push once on the indicated side of the door
and turn it to the front side of the projector.