Filter
Top Products
Service Mode
11-3
5975947 BARCOGRAPHICS 9200 120297
Change Password
This item is password protected when the password strap is
installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To get acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver
or coin counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly
and lay it down on the second part of the top cover.
RS 232 IN
REMOTE
PROJECTOR MODE :
GREEN - OPERATION
RED - STA NDBY
COMMUNICATION PORT
(800-PERIPHERALS)
RS232 OUT
IR-RECEIVED
DIAGNOSTICS
CODE
IR-RECEIVER
0
I
This de vice com plies with P art 15 of the FCC rules. Op eration
is subject to following two conditions :
(1) This device m ay not caus e harmful interfer ence
(2) This device m ust accept an y interf erence received
includ ing int erf eren c e that may cau s e u nd esired op er atio n
RGB V
RGB
H / C
V
On
98 279 10
RGB
H / C
V
H
RS 232 IN
REMOTE
PROJECTOR MODE :
GREEN - OPERATION
RED - ST ANDBY
COMMUNICATION PORT
(800-PERIPHERALS)
RS232 OUT
IR-ACKNOWLEDGED
IR -REC EI VED
DIAGNOS TICS
CODE
IR- REC EI VER
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device mus t accept any interference received
including interference that may ca use unde sired operation
Loosen the locking
screws.
Open the top cover
When the strap is on leg 2-3 or no strap is mounted, the password
function is enabled, when the strap is on leg 1-2, the password
function is disabled.
Password enabled
strap on leg 2-3
Password disabled
strap on leg 1-2