MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
User’s Guide Rev. 04
14
2 Installation
2.1 Initialization
▪ Connect the provided AC power cord to AC power inlet and turn on the front panel
switch
▪ The unit starts the initialization process. The message “Starting” will be shown on
the LCD display.
▪ After 17~20 sec, ‘MATRIXPRO-II DVI 16x16 Booting complete’ message will be
shown, along with hardware and firmware version information.
▪ The unit is now ready to receive commands from the user.
2.2 EDID Configuration
▪ EDID (Extended Display Identification Data) is an information set that is provided
by a display to describe its capabilities to a graphic source. It enables a graphic
source to identify the connected display.
▪ The information set includes: manufacturer, product type, phosphor or filter type,
timings supported by the display, display size, luminance data and (for digital
displays only) pixel mapping data.
▪ Once the graphic source reads the information set (usually during the booting
process), the EDID conveys the optimal format for a connected display.
▪ The MATRIXPRO-II DVI supports storing EDID information to an EEPROM for each
Input.
▪ The MATRIXPRO-II DVI has four methods to set EDID values
1) Default Mode: default EDID information from the factory is loaded to an input
port
2) Output Copy Mode: read EDID from any target display and copy to an input
port
Typically, the IP address of PC connected to the network is configured by a
DHCP server. If the PC is connected directly to the router, the network server
will not able to assign the IP address. In this case, network information for
the PC should be set manually.
The default IP address of MATRIXPRO-II DVI 16x16 is 192.168.0.246. Before
connecting MATRIXPRO-II DVI 16x16 to your network, please verify the
availability of IP address in your network. The IP address can be reconfigured
by front panel key button, PC program or command lines over RS-232 or
TCP/IP.