Filter
Top Products
MatrixPRO-II DVI 16x16 Router
________________________________________________________________________
User’s Guide Rev. 04
28
5.1.1 Connect Info
▪ Select the connection method to be either RS-232 and Ethernet (UDP) by
clicking the corresponding radio buttons.
▪ For RS-232 control, enter the COM port number of your PC and select baud
rate. The baud rate of your PC should be the same as the MATRIXPRO-II DVI
16x16 baud rate. (115200 is default)
▪ For Ethernet control, enter the IP address of the MATRIXPRO-II DVI 16x16 and
port number. 3000 is the default port number for the MATRIXPRO-II DVI 16x16.
▪ Click save button and close Set Config window then click Connect button on PC
program of MATRIXPRO-II DVI 16x16 to start it.
▪ If the connection is properly made, current status of MATRIXPRO-II DVI 16x16
will be shown at the bottom side of PC program.
5.1.2 Channel Name
▪ User can create specific names for all inputs and outputs to distinguish them
▪ On Fig 5.2, The name of Camera #1 was assigned to Input CH05 and Wall
display #3 for output CH07.
▪ Click the Save button to save your inputs. After savings, your inputs will be
applied on the PC program as shown in Fig 5-1.
5.1.3 Video Generator
▪ Select the resolution and pattern of video generator.
▪ Click Apply button to save it.
5.1.4 Control Lock Mode
▪ Locks and unlocks the controls such as Web, Data control (RS-232, TCP/IP and
UDP) and key button input.
▪ Click Apply button to save it.
5.1.5 Network
▪ Changes the network information of MATRIXPRO-II DVI 16x16 .
▪ Click Apply button to save it.