Filter
Top Products
5. General device settings Touch panel
5.2 Add a custom logo in touch panel
About a custom logo
The touch panel software allows to place a custom logo on the upper left corner of the touch screen. The
software provides an area of 90 x 90 pixels. Any image larger than 90 x 90 pixels will be proportionally
scaled to match inside this area. The file must be a bitmap file (bmp, jpe g, jpg, png, ...).
Current active logo
To display the current active logo in DC Toolset, click on Reload.Thefile is downloaded from the touch
panel and a preview will be shown within the rectangular square.
Image 5- 2
Reload c urrent logo
How to add or change a logo
1. Click on Change... (a). (image 5-3)
The Change customer logo window opens (b).
2. Fill out the path and file name (c1) and click OK
Or,
click on Load (c2).
A browse window opens (d).
3. Browse to the desired file (e) a nd click Open (f).
A preview is shown in the Change customer logo window (g). (image 5-4)
4. If this is the file, click OK (h).
An upload question is displayed (i).
5. Click Yes to upload the image to the touch panel (j).
When the upload is finished (k), an info window is displayed with the message : New logo is set in touch
panel”.
6. Click OK to continue (l).
44
R59770449 DC TOOLSET 15/12/2009