Filter
Top Products
Controlling
8-4
Controlling
8-4
5975696 BARCODATA 2100 140798
5975696 BARCODATA 2100 140798
How to Display a Projector Address?
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address
will be displayed in a 'Text box'. This text box disappears after a few seconds.
To continue using the RCU, it is necessary to enter the same address with the digit buttons
(address between 0 and 9). For example : if the Address key displays projector address
003, then press "3" digit button on the RCU to set the RCU's address to match the projector's
address.
How to Program an Address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address
with the digit buttons. That address can be any digit between 0 and 9.
When programming '0', zero address, the RCU will control any projector regardless of
the projector's address. This feature allows multiple projectors with different addresses
to be controlled by a single RCU.
Picture Controls with Direct Access.
When an image control is pressed, a text box with a bar scale, icon and function name
of the control, e.g. 'brightness...' appears on the screen (only if text is ON). See example
screen. The length of the bar scale and the value of the numeric indication indicate the
current memorized setting for this source. The bar scale changes as the + or - buttons
of the control on the RCU are pressed or the + or - buttons on the local keypad.
Brightness Control
A correct 'brightness' setting is important for good image reproduction.
Use the + button for a higher brightness.
Use the - button for a lower brightness.
PROJECTOR ADDRESS
001
BRIGHTNESS
0
10050
How to Display a Projector Address?
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address
will be displayed in a 'Text box'. This text box disappears after a few seconds.
To continue using the RCU, it is necessary to enter the same address with the digit buttons
(address between 0 and 9). For example : if the Address key displays projector address
003, then press "3" digit button on the RCU to set the RCU's address to match the projector's
address.
How to Program an Address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address
with the digit buttons. That address can be any digit between 0 and 9.
When programming '0', zero address, the RCU will control any projector regardless of
the projector's address. This feature allows multiple projectors with different addresses
to be controlled by a single RCU.
Picture Controls with Direct Access.
When an image control is pressed, a text box with a bar scale, icon and function name
of the control, e.g. 'brightness...' appears on the screen (only if text is ON). See example
screen. The length of the bar scale and the value of the numeric indication indicate the
current memorized setting for this source. The bar scale changes as the + or - buttons
of the control on the RCU are pressed or the + or - buttons on the local keypad.
Brightness Control
A correct 'brightness' setting is important for good image reproduction.
Use the + button for a higher brightness.
Use the - button for a lower brightness.
PROJECTOR ADDRESS
001
BRIGHTNESS
0 10050