Filter
Top Products
11
.2 MODEM CONNECTION
Connect the phone line to the RJ-11 connector on the V93A with a RJ-11
cable.
5 OPERATION
a. You are ready to perform commands when a terminal or PC is
communicating with:
(1) the V93A's EIA-232 port.
(2) a remote modem is communicating with the V93A’s
modem.
b. If you are using a PC, you can communicate with the V93A by
using a terminal emulation program or by using a software communications
program that emulates a terminal. BayTech supplies an utility diskette which
includes TERM.EXE, a terminal emulation program, to put your PC into
terminal emulation mode. Popular communication software packages such as
PROCOMM PLUS(R) by Data Storm Technologies, also provide terminal
emulation capabilities and allow for communications with the V93A.
c. If configuring the V93A from the EIA-232 port, configure the host
terminal’s serial parameters to match those of the V93A. From the factory,
the V93A is set at 9600 baud, 8 data bits, 1 stop bit no parity and
XON/XOFF disabled.
.1 LOGIN PASSWORD
Once the V93A has been connected to the phone line and configured for the
desired parameters, a remote host computer can make a connection to the
V93A modem over a dial line and perform data acquisition and control
functions with the various M Series I/O modules. The V93A will send a
message similar the following when a remote host computer establishes a
connection:
M-Series V93A DAC Host