Filter
Top Products
15
.5 UNIT RESET
Users can instruct the M-Series DAC with the V93A module, to “reset” by
using the Menu Selection Method to reset the unit. The Unit Reset command
does not affect any saved configuration parameters that have been changed
from the default values.
By responding to the Enter Request: message at the end of the menu with
“R”(Unit Reset), you will reset the M-Series unit.
Device A (2,1).................... 1
Device B (2,2).................... 2
Device C (2,3).................... 3
Device D (2,4).................... 4
Device A (3,1).................... 5
Device B (3,2).................... 6
Device C (3,3).................... 7
Device D (3,4).................... 8
Configure ............................... C
Manual Mode ............................. M
Exit......................................X
Unit Reset .............................. R
Logout .................................. T
Enter Request: R
The M-Series DAC unit has been reset.
Important: The Unit Reset command will terminate communications with
connected equipment to the M-Series DAC.
You must re-establish communications with the M-Series DAC system after
the unit has been reset.
The Menu is invoked by sending the Attention Character(default ;;;;;) to
the V93A host module five times. The V93A will respond with a menu similar
to the following, if two Serial I/O modules are installed.
.6 LOGOUT