Filter
Top Products
30
PPTP supports on-demand, multi-protocol and virtual private networking over public networks,
such as the Internet.
5.4 Traffic Shaping
Traffic Shaping is an agreement between the carrier and the subscriber to regulate the
average rate and “burstiness” or fluctuation of data transmission over an ATM network. This
agreement helps eliminate congestion, which is important for transmission of real time data
such as audio and video connections.
Peak Cell Rate (PCR) is the maximum rate at which the sender can send cells. This parameter
may be lower (but not higher) than the maximum line speed. 1 ATM cell is 53 bytes (424 bits),
so a maximum speed of 1 Mbps gives a maximum PCR of 2415 cells/sec. This rate is not
guaranteed because it is dependent on the line speed.
Sustained Cell Rate (SCR) is the mean cell rate of a bursty, on-off traffic source that can be
sent at the peak rate, and a parameter for burst-type traffic. SCR may not be greater than the
PCR; the system default is 0 cells/sec.
Maximum Burst Size (MBS) is the maximum number of cells that can be sent at the PCR. After
MBS is reached, cell rates fall below SCR until cell rate averages to the SCR again. At this
time, more cells (up to the MBS) can be sent at the PCR again.
The following figure illustrates the relationship between PCR, SCR and MBS.
5.5 Configuring WAN Setup
To change your BIPAC-5100S’s WAN remote node settings, click WAN. The screen differs by
the encapsulation.