Filter
Top Products
D8125INV
Installation
D8125INV Operation and Installation Guide
© 2005 Bosch Security Systems Page 11 49690E
3.0 Installation
The D8125INV is packaged with a Point Label Sheet. Save these, as you will use them when identifying the
point numbers on the Inovonics transmitters.
3.1 Mounting the D8125INV
1.
Select the knockout from the control panel enclosure
that will be used to route the wiring.
2.
Select the location from which the Inovonics FA400
Receiver wiring will be routed.
Wire
Knockouts
Figure 2: Choosing a Knockout for Wiring
Routing (D8103 enclosure shown)
3.
Remove the base of the
D8125INV and use the
screws provided with the unit
to mount it adjacent to the
control panel.
4.
Connect the wiring (see
Section 3.2 Wiring the
D8125INV to the Control
Panel and FA400 Receiver) to
the D8125INV and mount
the cover unit to the base.
D8125INV
Base
Control Panel
Enclosure
Figure 3: Mounting the D8125INV base