Filter
Top Products
D8125INV
Installation
D8125INV Operation and Installation Guide
49690E Page 16 © 2005 Bosch Security Systems
3.6 D8125INV Menu Selections
After the passcode is entered and the [ENT] key is pressed, the first of the following menus are displayed with each menu
displayed for three seconds before the next one is displayed.
Figure 14: D8125INV Menu Selections
To select a function, press the corresponding number or function key displayed. This menu scrolls for 5 minutes. After 5
minutes the display returns to showing idle text if no keypad activity is detected.
It is highly recommended that a walk test be performed after all programming is completed.
3.6.1 Beginning steps to add/edit/delete an RF Transmitter
Follow the steps below to begin the process of adding a new or existing RF transmitter:
1.
From the Idle Text screen, enter the passcode and press
[ENT] to access the main menu.
2.
Press 1 to add or edit an RF Transmitter (RF Xmtr).
3.
Enter the point number and press [ENT]
4.
At the Transmitter point status screen, do the following depending on the desired action:
To edit mode (see Section 3.6.1.1 Point Mode) and/or check-in time for new transmitters, press 1 and
see Section 3.6.1.3 Adding a new RF Transmitter, p. 18 or to reprogram existing transmitters, see
Section 3.6.1.3 Adding an existing RF Transmitter, p.20.
To delete a transmitter from the D8125INV, press 2 and see Section 3.6.1.4 Deleting an RF Transmitter
p.21.