Brother 7500 Label Maker User Manual


 
75
Appendix
The label is not printed
after pressing p.
Has text been entered?
A label will not be printed if there
is no text entered.
Is the tape cassette installed
correctly, and is there enough tape
remaining?
Check that the tape cassette is
installed correctly, and that there is
enough tape remaining.
Is the end of the tape bent?
If bent, cut the bent section of tape
with scissors and thread the tape
through the tape exit slot correctly.
Is the tape jammed?
If jammed, remove the tape
cassette, carefully pull out the
jammed tape, and then cut the tape
with scissors. Check that the end of
the tape passes through the tape
guide, and reinstall the tape
cassette.
Is the tape compartment cover
open?
If so, close the tape compartment
cover correctly.
The LCD messages are
displayed in a foreign
language.
Is the language set properly?
Refer to
Changing the
Language on page 12 and select
the desired language for the LCD
messages.
The label is not printed
correctly.
Is the tape cassette installed
correctly?
When installing a cassette, press
firmly until it clicks into place.
Is the print head clean?
If not, clean the print head using a
cotton swab or optional print head
cleaning cassette (TZ-CL4).
Is the rechargeable battery pack
charged sufficiently?
If the battery indicator comes on,
charge the rechargeable battery
pack.
The ink ribbon is
separated from the ink
roller.
Is the ink ribbon in the tape cassette
loose, or did you pull on the label
coming out of the tape exit slot?
If the ink ribbon is broken replace
the tape cassette. If not, leave the
tape uncut and remove the tape
cassette, then wind the loose ink
ribbon onto the spool as shown in
the figure.
The P-touch stops while
printing a label.
Is there enough tape remaining in
the tape cassette?
The striped tape indicates you have
reached the end of the tape. Replace
the tape cassette when the striped
tape appears.
Are the batteries weak and is the
AC adapter disconnected?
Replace all batteries or connect the
AC adapter directly to the P-touch.
Problem Cause Solution
Spool
PT75007600uk.book Page 75 Thursday, July 10, 2008 9:39 AM