Filter
Top Products
VI - 2
Messages on the LCD Probable Cause
DOCUMENT JAM n Document loading error
(1) The document rear sensor detects no leading edge of a
document within 10 seconds from the start of document
loading operation.
(The document rear sensor stays OFF even after the
document has been fed when the document front sensor
was ON.)
(2) The loaded document is too short.
(Since the document is shorter than the distance between
the document front and rear sensors, the document front
sensor is turned OFF before the document rear sensor is
turned ON.)
CLEAN UP SCANNER In the scanning compensation data list printed by the mainte-
nance-mode function code 05, less than fifty percent of the
white level data is faulty.
(This message may appear only in the maintenance mode.)
SCANNER ERROR In the scanning compensation data list printed by the
maintenance-mode function code 05, fifty percent or more of
the white level data is faulty.
(This message may appear only in the maintenance mode.)
TONER LOW The toner sensor has detected that there is not enough toner.
TONER EMPTY The toner sensor has detected that there is no toner. If this
message appears, recording is no longer possible.
SET CARTRIDGE The toner sensor has detected that no toner cartridge is loaded.
COOLING DOWN
PLEASE WAIT
(Appear alternately.)
The toner thermister has detected that the toner temperature
exceeded the specified level. If the temperature exceeds the
preset level, recording is no longer possible.
MACHINE ERROR XX
PRESS STOP KEY
(Appear alternately.)
"XX" indicates an error code. Refer to [ 2 ] on pages VI-4 and
VI-5.
CHANGE DRUM SOON The service life of the drum unit will expire soon. This message
appears for one minute.
(You can turn this message indication on or off by the
maintenance-mode function code 10, WSW30, selector 8.
Refer to Chapter V, Section 3.5.)
PC BUSY OR FAIL After connected with the host computer, the equipment has
received no response from the computer. (A communications
error has occurred.)