Filter
Top Products
IV - 10
1.5 Panel Rear Cover and Control Panel
(1) Place the control panel ASSY upside down.
If you do not need to remove the ADF parts, CIS shield film 1, antistatic brushes, shield film,
document pressure bar, or document rear sensor actuator, skip to step (6),
(2) To remove the ADF parts (spring plates, separation rubber and anti-vibration rubber), remove
the screw.
(3) To replace the CIS shield film 1, antistatic brushes and shield film, remove them.
NOTE: Once removed, they will become unusable and new parts will have to be put back in.
(4) To remove the document pressure bar, pull either of supports "a" provided on the panel rear
cover outwards and then lift the pressure bar up and towards the rear to release the three tabs
from the cutouts provided in the panel rear cover. The spring also comes off.
(5) To remove the document rear sensor actuator, pull either of supports "b" on the panel rear
cover outwards.