Filter
Top Products
50 Chapter 9
Remote Commands
Follow the commands below to access features remotely. When you call the machine and enter your
Remote Access Code (the factory setting is 1 5 9 ), the system will signal you with two short beeps
to enter a remote control command.
Change Fax Forwarding Setting
Press 9 5
then to
Turn Fax Forwarding OFF—Press 1.
Turn Fax Forwarding ON—Press 2.
Program Fax Forward Number—Press 4. Automatically turns Fax Forwarding ON.
Turn Fax Storage ON—Press 6.
Turn Fax Storage OFF—Press 7. (This is only possible if there are no faxes stored in the memory,
or if all faxes have been erased using Remote Control 9 6 3).
Retrieve or Erase a Fax
Press 9 6
then to
Retrieve all faxes—Press 2, then enter the number of remote fax machine and then press # #. After
the beep, hang up and wait.
Erase all fax messages—Press 3. If the data stored in the memory has not been printed before, it
will be printed first and then erased.
Check the Receiving Status
Press 9 7
then Press 1.
1 long beep—Received fax messages.
3 short beeps—No messages.
Change Receive Mode
Press 9 8
then for
TAD—Press 1.
F/T (FAX/TEL)—Press 2.
FAX—Press 3.
Exit Remote Operation
Press 9 0