Filter
Top Products
Remote fax options
61
10
Remote Retrieval 10
You can call your machine from any touch
tone telephone or fax machine, then use the
remote access code and remote commands
to retrieve fax messages.
Setting a Remote Access
Code 10
The remote access code lets you access the
remote retrieval features when you are away
from your machine. Before you use the
remote access and retrieval features, you
have to set up your own code. The factory
default code is inactive code (---l).
a Press Menu, 2, 5, 2.
2.Remote Access
b Enter a three-digit code using numbers
0-9, l, or #.
Press OK. (The preset ‘l’ cannot be
changed.)
c Press Stop/Exit.
Note
Do not use the same code as your fax
receive code (l 5 1) or telephone answer
code (# 5 1). (See Using external and
extension telephones on page 49.)
You can change your code at any time by
entering a new one. If you want to make your
code inactive, press Clear/Back in step b to
restore the inactive setting (---l) and
press OK.
Using your Remote Access
Code 10
a Dial your fax number from a telephone
or another fax machine using touch
tone.
b When your machine answers, enter
your remote access code (3 digits
followed by l).
c The machine signals if it has received
messages:
1 long beep — Fax messages
2 long beeps — Voice messages
(FAX-1960C only)
3 long beeps — Fax & Voice
messages (FAX-1960C only)
No beeps — No messages
d When the machine gives two short
beeps, enter a command.
The machine will hang up if you wait
longer than 30 seconds to enter a
command.
The machine will beep three times if you
enter an invalid command.
e Press 9 0 to reset the machine when you
have finished.
f Hang up.
Note
If your machine is set to Manual mode
and you want to use the remote retrieval
features, wait about 2 minutes after it
starts ringing, and then enter the remote
access code within 30 seconds.