Filter
Top Products
SETUP SEND
6 - 3
Dual Access
You can scan up to 50 documents into the fax memory, even while the
machine is receiving or sending another fax (from memory). You can set
temporary settings for each fax you're scanning, except Timer and Polling.
If you try to scan in and store a 51st fax, the machine will send it
immediately, without storing it in memory.
If you get a MEMORY FULL message while scanning the first page of a
fax, press
Stop
to cancel scanning. If you get a MEMORY FULL message
while scanning in a subsequent page, you'll have the option to press
Start
to
transmit the pages scanned so far, or to press
Stop
to cancel the operation.
1
Make sure the document feeder is empty.
2
Place the document in the feeder.
3
Enter the fax number.
4
Press
Start
. The machine starts scanning the document and the screen
displays the job number (#XX) of the fax and how much memory is
available. Then the machine starts dialing. You can immediately repeat
steps 1 through 4 for the next fax.
Your machine normally operates in Dual Access mode. However, you can
override Dual Access by using Real Time Transmission.
The number of documents you can scan into memory varies with the data
they contain.
Real Time Transmission
When Memory is full, the machine cannot continue to scan documents
into memory before sending. However, you can turn on REAL TIME TX;
place the documents in the feeder and enter the fax number. As soon as
the phone line is free, the machine starts dialing and sending the fax.
1
Place the document in the feeder.
2
For the FAX, press
Function
,
3
,
9
.
9.REAL TIME TX
For the MFC, press
Function
,
1
,
3
,
9
.
3
To change the default setting,
press
or to select ON (or OFF)
and press
Set
. Go to Step 5—OR—
For the next fax transmission only,
press
or to select
NEXT FAX ONLY and press
Set
.
4
For the next fax only, press or to
REAL TIME:ON?
SELECT <- -> & SET
select ON (or OFF) and press
Set
.