Filter
Top Products
3. Getting Started
GT-541
14
3. Getting Started
Before using your printer, it needs to be correctly setup as described in this chapter.
WARNING
Do not handle the power cord with wet hands, otherwise it may cause electric shocks.
Do not set up the printer in a dusty environment. If dust collects inside the printer, it may
cause fire or electric shocks or problems with correct operation.
Be sure to connect the ground. If the ground connection is not secure, you run a high risk of
receiving a serious electric shock, and problems with correct operation may also occur.
Do not bend the cords excessively or fasten them too hard with staples or anything similar
to secure cords, otherwise there is the danger that fire or electric shocks could occur.
CAUTION
Setting up and moving of the printer should only be carried out by a qualified technician.
The printer machine weighs approximately 100 kg. Transporting and setting up of the
printer should be carried out by four or more people.
The machine must be transported using the correct handling points only. Do not use the
cartridge housings to move the machine. The machine may tip over or fall down and cause
injury.
The printer must be used on a suitable stable surface, otherwise it may tip over or fall down
and cause injury.
Furthermore, the table that supports the printer should be at least 100 cm in width and 80
cm in depth, and should be able to bear a weight of 150 kg or more.
Do not set up the printer in a place where it will be affected by vibration. It may become
unbalanced and fall down, which cause injury or damage to the printer.
Do not connect the power cord until setup is complete, otherwise the printer may operate if
the power switch is turned on by mistake, which could result in injury.
Do not climb onto the printer or place heavy objects on top of it, otherwise it may become
unbalanced and tip over or fall down and cause injury.