Filter
Top Products
- 7 -
Part names
Outside of the machine
DC connector Located on the left, backside of the machine. Aperture for the AC
adapter.
Top cover For replacing the film cartridge and cutter units.
Viewing window Located on the top cover. Allows you to make sure that the
correct type of film cartridge is loaded into the machine.
Document tray Where documents to be laminated are placed.
Document supporter Supports the document for insertion.
Document guide Aligns the left edge of the paper for proper document insertion.
Control panel Power switch and function button area.
Document output Location where the document exits the machine.
Corner cutter slot Allows you to trim the corners of your document after laminating.
Corners of a document are automatically trimmed after insertion
into the corner cutter slot.
Corner cutter tray The corner of your laminated document is placed on this tray to
position it into the corner cutter slot.
Corner cutter dust box Collects trimmings from the corner cutter.
AC adapter Plugs into an electrical outlet and the DC connector on the
machine.
Inside of the machine
Film cartridge Contains the roll film. The label on the cartridge identifies the film
type.
You can use 9.0 inch (A4) or 4.8 inch (A6) width LC cartridges
with this machine.
Roller release lever Releases the roller.
Roller holder lock button Locks the roller holder.
Roller holder Holds the roller unit.
Side cutter arm Arm for the side (vertical) cutter unit.
Side cutter units Blades for side (vertical) cutting.
Top/bottom cutter units Blades for top/bottom (horizontal) cutting.
Roller Feeds the document into the unit.
Document guide
Document supporter
Document tray
Viewing window
Control Panel
Corner cutter slot
Corner cutter dust box
Document output
Top cover
DC connector
Film cartridge
Roller holder
Roller release
lever
Side cutter arm
Top/bottom cutter unit
Roller holder
lock button
Roller
Side cutter
unit