Filter
Top Products
Chapter 9
86
Additional Message
Center operations
9
Setting the maximum time for
incoming messages 9
Your machine’s default setting will save
incoming messages up to 30 seconds long.
To change this setting follow the steps below:
a Press MENU.
b Press a or b to display Fax.
c Press Fax.
d Press a or b to display
Setup Msg Ctr.
e Press Setup Msg Ctr.
f Press ICM Max.Time.
g Press the maximum time setting for
incoming messages (30, 60, 120 or
180 seconds).
h Press Stop/Exit.
Setting toll saver 9
When the toll saver feature is on, the machine
will answer after two rings if you do have
voice or fax messages, and after four rings if
you do not have any messages.
This way, when you call your machine for
remote retrieval, if it rings three times, you
have no messages and can hang up to avoid
a toll charge.
The toll saver feature is only available when
Message Center mode is on. When toll saver
is On, it overrides your ring delay setting.
If you are using Distinctive Ring, do not use
the Toll Saver feature.
a Press MENU.
b Press a or b to display Fax.
c Press Fax.
d Press a or b to display
Setup Receive.
e Press Setup Receive.
f Press a or b to display Ring Delay.
g Press Ring Delay.
h Press Toll Saver.
i Press On (or Off).
j Press Stop/Exit.