Filter
Top Products
Wireless Configuration for Windows
®
32
4
m To communicate with the un-configured wireless machine, temporarily change the wireless settings on
your PC to match machine’s default settings shown on this screen. Click Next.
Note
• If a message to restart your PC appears after the wireless settings have been changed, restart your PC
and then go back to step 4 and continue with the install skipping steps 11, 12 and 13.
• For Windows® XP SP2 usersYou can temporarily change the wireless settings on your PC, following the
steps below:
1 Click Start and then Control Panel.
2 Click Network Connections icon.
3 Select and right click Wireless Network Connection. Click View Available Wireless Networks.
4 You can see the Brother wireless machine in the list. Select SETUP and click Connect.
5 Check the Wireless Network Connection status. It may take a few minutes to change from 0.0.0.0.
to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1 and 254).
n The following list appears. If the list is blank, check if the access point and the machine are powered on,
and then click Refresh. Choose the machine you wish to configure, and click Next.