Filter
Top Products
Control panel setup
80
6
Comm.Mode 6
This field displays the current wireless network communication mode; Ad-hoc or Infrastructure.
a Press Menu.
b Press a or b to select LAN.
Press OK.
c Press a or b to select WLAN Status.
Press OK.
d Press a or b to select Comm. Mode.
Press OK.
e The current wireless network communication mode will be displayed; Ad-hoc or Infrastructure.
f Press Stop/Exit.
Setup Misc. 6
Wired LAN (for wired network only) 6
Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT
full or half duplex mode by auto negotiation.
100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half
Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset
(default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a Press Menu.
b Press a or b to select LAN.
Press OK.
c Press a or b to select Setup Misc..
Press OK.
d Press a or b to select Wired LAN.
Press OK.
e Press a or b to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.
f Press Stop/Exit.