Filter
Top Products
44
1 Press g, then Z.
2 Press l or r until LENGTH ADJUST is displayed.
3 Press u or d until the desired setting is displayed, and then press n.
Specifying if the PERSONAL symbol category is
continually updated
You can specify whether symbols continue to be added to the
PERSONAL
symbol category
(with the older symbols deleted) when the category becomes full (
ON
) or symbols are no longer
added after the
PERSONAL
symbol category becomes full (
OFF
). (The default setting is
ON
.)
1 Press g, then Z.
2 Press l or r until SYMBOL SAVE is displayed.
3 Press u or d until the desired setting is displayed, and then press n.
Changing the units of measure
The units used for displaying measurements can be set to millimeters (mm) or inches
(inch). (The default setting is inch.)
1 Press g, then Z.
2 Press l or r until UNITS is displayed.
3 Press u or d until the desired setting is displayed, and then press n.
Displaying version information
This function can be used to display the version information for the P-touch labeler
software and built-in symbol set.
1 Press g, then Z.
2 Press l or r until VERSION INFO is displayed.
3 Press u or d until the desired version information is displayed.
4 Press n to exit Setup mode.
PT75007600us.book Page 44 Wednesday, February 27, 2008 2:50 PM