Filter
Top Products
74
6
6
Appendix
Resetting the P-touch Labeler
You can reset the internal memory of your P-touch labeler when you want to clear all
saved label files, or in the event the P-touch labeler is not working properly.
1 Turn off the machine and then while holding down g and R, press o to
turn the machine back on.
2 Release g and R.
The P-touch labeler turns on with the internal memory reset.
Troubleshooting
☞ Release o before releasing the other keys.
☞ All text, format settings, option settings and stored label files (except for the Auto
Format templates), are cleared when you reset the P-touch labeler. Language and unit
settings will also be cleared.
Problem Cause Solution
The screen ‘locks’, or the
P-touch labeler does not
respond properly.
Refer to Resetting the P-touch Labeler above and reset the internal
memory to the initial settings. If resetting the P-touch labeler does not
solve the problem, disconnect the AC adapter and remove the battery for
more than 10 minutes.
The display remains blank
after turning on the
power.
Is the AC adapter connected
correctly?
Check that the AC adapter designed
exclusively for your P-touch labeler
is connected correctly.
Are you using the correct AC
adapter?
Make sure that you are using the
AD-18 designed exclusively for
your P-touch labeler (included in
package).
Is the battery installed correctly? Remove and re-install the battery.
Is the rechargeable battery pack
charged sufficiently? (for PT-7600
only)
The rechargeable battery pack’s
charge may be low. Charge the
rechargeable battery pack. (The
rechargeable battery pack’s charge
may run low even when you are not
using the P-touch labeler.)
PT75007600us.book Page 74 Wednesday, February 27, 2008 2:50 PM