Filter
Top Products
Remote Fax Options (FAX-T74)
53
ADVANCED USE
Remote Commands
Follow the commands below to access features remotely. When you call the fax machine and enter
your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a
remote control command.
Remote control commands Detail Operation
95 Change Fax Forwarding
Setting
1 OFF If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the
conditions (ex. registering fax forwarding) have not been
completed. You can register your fax forwarding number by
using 4. FAX FWD NO. Once you have registered the
number, the machine will automatically turn to “FAX FWD
: ON” mode. Then, receive a Memory Status List by entering
961. Check the List to make sure the Fax Forwarding
number you registered is correct. Then enter the
confirmation command 955. Now the machine will start Fax
Forwarding.
2 Fax forwarding
4 FAX FWD No.
6 FAX STORAGE ON You can set FAX STORAGE ON or OFF.
7 FAX STORAGE OFF
96 Retrieve FAX
1 Memory Status List You must use a remote fax machine in order to receive a List
or stored fax message(s).
2 Retrieve all FAX
3 Erase FAX in the
memory
If you hear one long beep, you can erase fax message(s) from
the memory.
97 Check the receiving status You can check whether your fax machine has received any
fax message(s). If yes, you will hear one long beep. If no,
you will hear three short beeps.
1 DOC
98 Change Answer Mode If you hear one long beep, you can change the answer mode.
If you hear three short beeps, you cannot change it.
1 TAD
2 F/T
3 FAX
90 Exit After a long beep, you can exit remote control.