Filter
Top Products
Chapter 5: Local Management
5-64 2E43-51/2E43-51R User’s Guide
• LockedOnAddr – The source address of the last frame received (or the
source address entered in the Port Level Security Configuration
screen, if one is entered) is used for security purposes. Once a secure
address is defined on a port, only those frames received with that same
source address are processed on that port. Any other frame detected
with a different address is considered as an intruder, causing the device
to execute the actions selected in the Action On Intruder field.
Action On Intruder (Toggle)
Used to select the actions taken for the selected security state. There are
two fields to select the actions. Both toggle to activate or deactivate the
action.
• DisablePort/NoDisable – DisablePort causes the switch to turn off the
port that had a security violation. With NoDisable set, the port is not
turned off.
• SendTrap/NoTrap – SendTrap causes the switch to send an SNMP trap
when a port detects a security violation. With NoTrap set, no SNMP
trap is sent.
5.19.1 Setting the Repeater Level Security
To set the repeater security for each connector, proceed as follows:
1. Use the arrow keys to highlight the STATE field for the interface
connector.
2. Use the SPACE bar to step to the appropriate security level (Secure or
NonSecure).
3. Use the arrow keys to highlight the Lock/Learn field for the
connector.
4. Use the SPACE bar to step to the appropriate type of security
(LockOnNext or LockedOnAddr).
5. If the security level chosen causes the DisablePort and SendTrap
fields to display under Action On Intruder, use the arrow keys to
highlight the DisablePort field. If the security level chosen does not
cause the fields to display under Action On Intruder, proceed to step 9.
6. To change the DisablePort setting to NoDisable, press the SPACE
bar to toggle the setting.