Cabletron Systems 2E43-51 Switch User Manual


 
Chapter 5: Local Management
5-86 2E43-51/2E43-51R User’s Guide
Special Commands Allow the user to exit from Network Tools. The
commands are done, exit, and quit.
The commands are presented in the following format:
command:
Syntax: Shows the required command format. It
indicates where arguments, if any, must be
specified.
Description: Briefly describes the command and its uses.
Options: Lists any additional fields in the appropriate
format which may be added to the command.
Example: Shows an example of the command.
5.26.1 Built-in Commands
The built-in commands listed in this section activate functions on the LM
managed device or devices being accessed through Network Tools.
arp:
Syntax: arp <options>
Description: The arp command provides access to the ARP
(Address Resolution Protocol) cache, enabling
you to view cache data, delete entries, or add a
static route. Super-user access is required to
delete an entry or add a static route.
NOTES
The conventions used in describing the commands in Network
Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by
user is shown in bold Helvetica font.
To abort the output or interrupt a process, press the CONTROL
key and c key simultaneously, designated as ^C here.