Filter
Top Products
Appendix C: Optional Installations and Mode Switch Bank Settings
C-4 2E43-51/2E43-51R User’s Guide
2. If the 2E43-51 is rack mounted, remove it from the rack and remove
the rackmount brackets (refer to Chapter 3, Optional Installations
and Mode Switch Bank Settings).
3. Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See Figure C-1.)
4. Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off of the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
Figure C-1 Removing the Chassis Cover
C.2.1 Setting the Mode Switch
Figure C-2 shows the location of the mode switches and the switch
settings for normal operation. These switches are set at the factory and do
not need to be changed.
2251-30
Chassis Cover
Chassis
Cover Screws (7)
Note: If the device was rack mounted, the four screws fastening the cover to
the front panel are removed and installed along with the rackmount brackets.
Front Panel