Filter
Top Products
HSIM-W87 User’s Guide 2-1
CHAPTER 2
INSTALLATION
To install the HSIM-W87 the following items are required:
•
Antistatic wrist strap (shipped with the HSIM-W87)
•
Phillips screwdriver
2.1 UNPACKING THE HSIM-W87
Unpack the HSIM-W87 as follows:
1.
Remove the HSIM-W87 from the shipping box.
2.
Leave the module in its antistatic bag until you are ready to install it.
3.
Attach the antistatic wrist strap (refer to the instructions on the
antistatic wrist strap package for proper use).
4.
After removing the module from its antistatic bag, visually inspect the
device. If you notice any signs of damage, contact the Cabletron
Systems Global Call Center immediately. Refer to Section 1.7 for
instructions. Save the antistatic bag in the event the module must be
reshipped or relocated.
NOTE
Before attempting to use the HSIM-W87 you should be familiar
with the
IEEE 802.3 Specifications,
and T1 and T3 Networking.
!
CAUTION
The HSIM-W87 and the host platform are sensitive to static
discharges. Use an antistatic strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the HSIM-W87 or host platform.