Filter
Top Products
Installing the HSIM-W87
HSIM-W87 User’s Guide 2-5
9. Secure the HSIM-W87 to the module faceplate using the mounting
screws saved in Step 5.
10. Secure the HSIM-W87 to the module standoffs using the standoff
screws included in the HSIM-W87 shipping materials.
11. Reinstall the interface module in the chassis.
12. Reattach the network cabling to the interface module.
2.2.2 Installing the HSIM-W87 in a Standalone Device
To install an HSIM-W87 into a standalone device (e.g., 2H252-25R)
perform the following steps:
1. Power down the device and remove the power cord.
2. Note the ports that have cables attached to them. Write down the ports
and label the cables to make it easier to reattach the network properly
after the installation. Then disconnect those cables from the ports.
3. Attach the antistatic wrist strap (refer to the instructions outlined on
the antistatic wrist strap package).
4. Remove the standalone device chassis cover (refer to your specific
standalone device documentation for instructions on removing the
chassis cover).
5. Refer back to Figure 2-1 and remove the two faceplate mounting
screws and the HSIM coverplate. Save the screws.
6. Refer back to Figure 2-2 and place the HSIM-W87 behind the
standalone device faceplate.
7. Align the HSIM connector of the HSIM-W87 with the pins on the
standalone device.
To install the HSIM-W87 in a standalone device the device
must first be powered down. Ensure that you remove the power
cord and ONLY the screws required to remove the chassis
cover.